The main introduction of silicone rubber insulated and sheathed power vga extension cable for

Conditions of Use AC rated working voltage : 0.6/1KV
Working temperature: Fixed installation : -60 ℃ ~ 180 ℃
Non- fixed laying : -40 ℃ ~ 180 ℃
Installation Laying Low temperature: not lower than -40 ℃
Cable bending radius : not less than six times the cable diameter
Cable has excellent antioxidant , ozone resistance, ultraviolet radiation

performance, long-term outdoor use crack does not WISDOM utp cable  occur ; has excellent

electrical properties, resistance to corona and arc resistance is also

very good ; has excellent mechanical properties, in under 150 ℃ high

temperature mechanical properties far superior to General rubber sheathed

power cables ; has good chemical resistance , resistance to fuel and oil

properties. Odorless, tasteless , non-toxic , low -temperature surface

activity and low suction performance . Cable Schema 5.1 Conductor copper

conductor according to GB / T 3956 requirements.
Conductor smooth surface, no oil , no damage insulation burrs , sharp

edges. 5.2 silicone rubber insulation materials WISDOM Mini HDMI cable  insulation materials ,

insulation tightly extruded over the conductor , the conductor does not

hurt and easy to peel , insulating surface flat and smooth .
Insulation thickness meets standards, the average insulation thickness is

not less than the nominal value , less than the thickness of the thinnest

90%-0.1mm nominal value. 5.3 Cabling
Insulated core stranding , cabling is twisted to the right direction,

after a cable wrapped with polyester film overlay package with overlapping

around the corrugated rate of not less than 20%. 5.4 To make the filling

into the cable core cable round, as needed to allow  WISDOM hdmi wall plate the use of non-

hygroscopic material as fill. 5.6 outer sheath outer sheath material with

silicone rubber sheath material.
Extruded jacket tightly insulated wire in  the cable core or core, and the

core is not easy to peel injury . Sheath smooth surface, uniform color .

Sheath thickness meets standards, the average sheath thickness is not less

than the nominal value, the thickness of the thinnest of not less than

85%-0.1mm nominal value.